电极流动分析仪的研制和应用

采用固定电极测试状态的方法，将流动技术引入到离子电极直接电位分析法中，设计并试制了电极流动分析仪。配用市售硝酸根电极、钠电极、氟电极、氯电极和氨电极进行了环境样品的测定。结果表明，电极流动分析仪法的分析速度比直接电位法提高２－３倍，变异系数，２．９％－５．０％之间，回收率在９０％－１０５％之间；直接电位法变异系数在２．３％－６．７％之间，加收率在９０％－１０９％之间。     

A study on Se application for improving the soil in the environment at lower Se level

A result that application of sodium selenite or fly ash to some of soilin loess plateau can increase Se content in wheat grain has been demonstrated by the pot and field experiments, and added Se in soil can last its availability for 3 years. So this is a good measure for improving the low Se soils and preventing the Kaschin-Beck disease.     

4—氯苯甲酸钠的光催化氧化降解及其影响因素

本试验采用P－25TiO2，光催化剂，对4－氯苯甲酸钠的光催化氧化降解及污染物初始浓度，催化剂投加量和入射光强等因素的影响进行了研究，研究发现污染物初始降解速率与其初始浓度的关系遵循Langmuir-Hinshelwood模式，其中半饱和浓度常数Ks不仅是催化剂和污染物种类的函数，而且也是入射光强的函数，催化剂投加量存在一限值，当低于此限值时，污染物降解速率由于催化剂浓度的不足受到影响而下降，当高于此限值时，污染物降解速率受催化剂投加量的影响变小，在本试验4－CBA－Na浓度为0.15-0.6mmol／L时该催化剂限值浓度大约为0.4g/L，在入射光强为1-7mW/cm^2和催化剂浓度为0.4g／L下，污染物降解速率与光强成0.67次幂关系，经估算其量子效率为6．3％。     

Production of hydrogen by steam gasification of dehydrochlorinated poly(vinyl chloride) or activated carbon in the presence of various alkali compounds

Steam gasification of dehydrochlorinated poly(vinyl chloride) (PVC) or activated carbon was carried out in the presence of various alkali compounds at 3.0 MPa and 560°C–660°C in a batch reactor or in a semi-batch reactor with a flow of nitrogen and steam. Hydrogen and sodium carbonate were the main products, and methane and carbon dioxide were the minor products. Yields of hydrogen were high in the presence of sodium hydroxide and potassium hydroxide. The acceleration effect of the alkali compounds on the gasification reaction was as follows: KOH > NaOH > Ca(OH)₂ > Na₂CO₃. The rate of gasification increased with increasing partial steam pressure and NaOH/C molar ratio. However, the rate became saturated at a molar ratio of NaOH/C greater than 2.0.     

Optimization of extraction of oil and biodiesel from Thespesia populnea seed oil by alkali catalyst in India

Thespesia populnea oil was new source of biodiesel. Crude Thespesia populnea oil was used as feedstock for biodiesel production by alkali-catalyzed methanolysis. The reaction in the presence of NaOH as catalyst was carried out to investigate the optimum conditions and to study the effects of variables on the reaction. A methanol to oil ratio of 6:1, sodium methoxide catalyst concentration of 1.5%, mixing intensity of 250 rpm and reaction temperature of 60°C offered the best Thespesia populnea seed oil methyl esters (biodiesel) yield (92.6%). The methyl ester content under these optimum conditions was 92.6% w/w, and all of the measured properties of the Thespesia populnea biodiesel (TPME) met the international standards ASTM D 6751-02. The results reveal that all of the reaction variables in this study had positive effects on the reaction. The results of the present study indicated that TPME could be a potential alternative to petrodiesel     

Oxidation inhibition of sulfite in dual alkali FGD system

A laboratory-scale well-mixed thermostatic reactor with continuously blasting air was used to investigate the oxidation inhibition of sulfite in dual alkali flue gas desulfurization （FGD） system. The effects of operating parameters such as pH value and catalyst concentration on the oxidation were studied. Sodium thiosulfate was used in the system, and was found that it significantly inhabited the sulfite oxidation. In the absence of catalyst, sodium thiosulfate at 12.67 mmol/L had an inhibition efficiency of approximately 98%. While in the presence of catalyst, sodium thiosulfate at 26.72 mmol/L had an inhibition efficiency less than 85.0%. The oxidation reaction order of sulfite in the sodium thiosulfate was determined to be -1.90 and 4）.55 in the absence and presence of the catalyst, respectively. Apparent activation energy of oxidation inhibition was calculated to be 53.9 kJ/mol. Pilot tests showed that the consumption rate of thiosulfate agreed well with the laboratory-scale experimental results.     

水质测定中高锰酸盐指数(酸性法)影响因素的研究

探讨了水质测定中酸性法高锰酸盐指数的影响因素:加热时间、加热温度、溶液浓度、滴定速度、水样酸度,掌握了最佳试验条件,使测定结果更准确。     

Formation of chlorinated disinfection by-products in viticulture

Background, aim and scope  The use of sodium hypochlorite (HYP) in viticulture results in effluents which are contaminated with halogenated substances. These disinfection by-products (DBPs) can be quantified as group parameter ‘adsorbable organic halogens’ (AOX) and have not been determined in effluents of viticulture yet. The substances that are detected as AOX are unknown. The AOX can be composed of harmless substances, but even toxic contaminants. Thus, it is impossible to assess ecological impacts. The aim of this study is to determine the quantification of AOX and DBPs after the use of HYP. This will be helpful to reduce environmental pollution by AOX. Materials and methods  The potential of HYP to generate AOX was determined in laboratory-scale experiments. Different model solutions were treated with HYP according to disinfection processes in viticulture and conditions of AOX formation in effluents were simulated. AOX were quantified using the flask-shaking method and identified DBPs were investigated by gas chromatography–mass spectrometry. Results  Treatment with HYP resulted in the formation of AOX. The percentage conversion of HYP to AOX was up to 11%. Most important identified DBPs in viticulture are chloroform, dichloroacetic acid and trichloroacetaldehyde. In addition, the formation of carbon tetrachloride (CT), 1,1,1-trichloropropanone, 2,4-dichlorobenzoic acid and 2-chloro-/2,4-dichlorophenylacetic acid was investigated. It was demonstrated that reaction temperature, concentration of HYP and type of organic matter have important influence on the formation of chlorinated DBPs. Discussion  The percentage conversion of HYP to AOX was similar to other published studies. Although a correlation of single compounds and AOX is difficult, chloroform was the predominant AOX. Generation of the volatile chloroform should be avoided due to possible adverse effects. The generation of dichloroacetic acid is of minor importance on account of biodegradation. Trichloroacetaldehyde and 1,1,1-trichloropropanone are weak mutagens and their formation should be avoided. Conclusions  The generation of AOX and chlorinated DBPs can be minimised by reducing the concentrations of the organic materials in the effluents. The removal of organic matter before disinfection results in a decreased formation of AOX. HYP is an effective disinfectant; therefore, it should be used at low temperatures and concentrations to reduce the amount of AOX. If possible, disinfection should be accomplished by the use of no chlorine-containing agents. By this means, negative influences of HYP on the quality of wine can also be avoided. Recommendations and perspectives  Our results indicate that HYP has a high potential to form AOX in effluents of viticulture. The predominant by-products are chloroform, dichloroacetic acid and trichloroacetaldehyde. In further research, wastewaters from a winery and the in- and outflows of two sewage treatment plants were sampled during vintage and analysed. These results will be discussed in a following paper.     

洗涤剂中的磷对环境的影响及对策的探讨

本文介绍了关于洗涤剂中磷对环境影响的两种典型观点和解决的办法,并从经济和环境的角度进行全面的分析,得出合理的结论和建议。     

Experimental investigation of the performance of modified expanded graphite powder doped with zinc borate in extinguishing sodium fires

Sodium is the main cooling medium in the circuit of fourth-generation nuclear reactors, and its leakage constitutes a severe fire hazard because of its high chemical activity. In this study, expandable graphite (EG), which is a traditional sodium fire-extinguishing agent, was modified with zinc borate (ZB) as an intercalator, and the modified EG_ZB was characterized. Moreover, the effectiveness of the modified EG_ZB in extinguishing sodium fires was tested using a self-developed fire-extinguishing experimental device. This study's results indicated that EG, EG_ZB had a smaller particle size, higher thermal stability, higher fire-extinguishing speed, and lower powder mass consumption than EG. During the fire-extinguishing process, ZnO decomposed by ZB captured free radicals and inhibited the combustion reaction. Furthermore, B₂O₃ was adsorbed on the surface of the EG layer, which strengthened covering and asphyxiation. The findings of this study provide crucial information for effectively controlling fires caused by active metals and metallo-organic compounds.